Halcyon arrived with his car, here is a before picture.

Halcyon had a few dings as well which had been touched up.  He was also keeping his Toyota logo, so his pattern was pre-cut to fit the emblem.

Alan installs the top hood piece!

Jeff watches as Alan installs

Piece #1 is done. You can see the edge particularly in this piece because of the low angle lighting, later in the sun it is barely visible.

Starting piece number 2  on the car.

Alan stretches piece #2 a little for the best fit.

The new pattern piece #3 that does not go all the way to the bottom which makes the install MUCH easier! (the lower pieces fill this area in)

Smoothing down piece #3

The finishing touches with felt pad and hairdryer.

The middle spoiler lip, this is called piece #5 in the new pattern.

The spoiler is done. It was starting to get a little bit darker so the garage lights came on.

Alan gives the car a last minute check in the sun to make sure everything is attached as it should be.

Jeff and Alan, another Thumbs Up!

I wanted to take a picture from another angle to show that the edge line disappears depending on the angle and the lighting.

Tony arrived last, around 7:15pm so we did his at my complex, that's him in my car checking out my dash.

Cleaning off the front end.  Tony took off his emblem because he is getting the J-Spec badge.  He also has a plug to fill the hole where the dealer drilled for the license plate bracket.

Tony already had his radio shack antenna that was bent over from his 2 hour drive!

Someone wanted a picture of my Aluminum dash kit

Alan lays down piece #1

The finishing touches.

Tony watches in amazement as Alan trims the front edge of piece #1 for the best fit.

Tony helps Alan (as I supervise :-)

We are losing our sun as Alan lines up piece #2

The finishing touches on piece #2

Starting piece #3

Lining up the parking light and edges of piece #3

Alan works the details.

Getting dark so we brought out a lamp to throw some light on the situation.

Tony watches as Alan installs piece #4 the lower sections.

Alan does the lower piece on the other side.

If only Wayne had been here we would have had 3 yellows at once! :-)  The camera flash lit up the tail lights and my plate

Alan gives the thumbs up, and is looking a little "glazed" from his third install of the day!

Tony also had the mirrors done

Alan and Tony point out the finished product

Tony's testimonial video!

Page 3 of the Party!